Red Line CV-2 Grease with Moly

Details

Red Line CV-2 Grease is designed to withstand the extreme temperatures and pressures which occur in high-performance wheel bearings and CV-joints. The excellent high temperature stability, extreme-pressure protection, and water resistance enables it to out-perform even the best conventional or synthetic greases. Red Line CV-2 Grease can be used in a wide range of applications at temperatures ranging between -100°F to 500°F and provides good oxidation and corrosion resistance, low evaporation and oil separation, and has a minimum effect on rubber seals. The exceptional extreme-pressure performance and the fluidity of the synthetic oil allows increases in bearing life of 200% to 800%. Red Line CV-2 Grease contains a red moly compound which is a superior lubricant to black moly disulfide lubricants. Red Line CV-2 Grease may also be used in industrial applications such as high-temperature alternator bearings, high-speed ball bearings, conveyor bearings, worn gear drives, servo mechanisms, and applications where vibrations can cause fretting wear and corrosion to take place. Red Line CV-2 Grease will retain its consistency and extreme-pressure performance under high-temperature and high-shear conditions for extended periods, which extends the performance ranges of the lubricated components. Red Line CV-2 will slightly darken after high-temperature use; this darkening will not detrimentally effect the performance of the grease. Although Red Line CV-2 is compatible with small amounts of many petroleum-based greases, it is always good lubrication practice to thoroughly clean out the old grease to eliminate abrasive particles and to minimize the possibility of grease incompatibility.

• Outperforms the best conventional or synthetic greases and lubes.
• Withstands extreme temperature and pressure in wheel bearings, U-joints, and high-angle CV Joints.
• Excellent high-temp stability, extreme-pressure protection, and water resistance.
• Used in a variety of applications with operating temps from -100°F to 500°F.
• Strong resistance to oxidation and corrosion, low evaporation and oil separation with a minimum effect on rubber seals.
• Contains an organic moly for chassis lubrication and high temp/high speed industrial equipment.
• Synthetic fluidity allows increases in bearing life up to 200%.
• Will darken after high-temp use but is not detrimental to performance.