Luxon Gen3 Rubber Isolated Handlebar Mounts M10 Interface

Details

Upgrade your harsh solid bar mounts to rubber mounts with Luxon Gen3 design. The 4-post style bar mount is rubber isolated and designed to reduce vibration felt from the engine, eliminate twisting in small crashes and tip-overs, and absorb hard hits and track roughness without compromising steering precision. Three different rubber bushing hardness levels are included to fine tune the feel. Luxon mounts are lighter than stock, yet resist twisting up in crashes with the 4-post design.

These mounts fit stock triple clamps with an M10 interface, which includes Beta and many KTM, Husqvarna, and GasGas models that use a mount bolting directly to the top clamp (not ones with rubber cones). The mounts are the stock KTM height of 25 mm (bottom of bar to top of triple clamp) and offset (7 mm of bar position change when flipping the mounts around). Includes rubber isolated lower bar mounts, rubber bushings, upper bar clamps, high-strength steel clamp bolts, anti-seize, and instructions.

Three different hardness levels of rubber bushings are included at no additional cost. Soft (green) is for lighter riders, vet riders, or those with wrist injuries. Medium (yellow) is recommended for most off-road and motocross use, and hard (red) is recommended for aggressive motocross use and faster riders. It is also possible to mix different hardness levels of top and bottom bushings (for example, medium uppers with hard lowers) for further tuning.

Depending on the installation type, make and model of bike, bar mount position, etc., you may need to lightly trim plastic brackets and/or relocate hour meters or accessories to allow clearance for these bar mounts in some mount positions (typically not an issue on motocross bike installations).